Upgrade your Hilux with the A1 Platinum Bilstein Tour Pack from PPD Performance NZ. A load-matched suspension package pairing pre-assembled CalOffroad Platinum / Bilstein front coilovers and Bilstein rear shocks with NZ-sourced RAW 4x4 raised rear leaf springs. Choose the front spring to suit accessories and the rear spring to suit the weight you regularly carry.
The Bilstein front and rear monotube dampers help control unwanted suspension movement across rough roads, corrugations and uneven tracks. The assembled front coilovers use matched springs and dampers to support a more composed ride, while RAW rear leaf springs provide the spring capacity suited to permanent loads including tools, canopies and touring equipment. Actual performance depends on vehicle condition, tyres, accessories, loading and installation.
Application: Toyota Hilux N80/GUN-series 4WD (approximately 2015–2024; check specific variant). The front lift is approximately 75 mm (3 inches), but the RAW rear leaf springs provide approximately 40 mm of rear lift on the N80. This is not a 75 mm rear lift. Heights are nominal; actual lift varies with accessories, permanent load and existing suspension condition.
Choose rear spring rating based on regular, permanent carried weight rather than occasional cargo. Suspension modifications do not increase manufacturer GVM or axle limits. Ensure compatibility before ordering, especially for Rogue, GR Sport, wide-track and other special-edition Hilux models where applicable.
With the higher front lift, upper control arms, a differential drop and other geometry correction components may be required depending on the vehicle setup; these items are not included in this kit unless separately specified. Low Volume Vehicle (LVV) certification may be required in New Zealand depending on the vehicle and modifications; confirm before ordering.
CalOffroad Platinum/Bilstein front assemblies and Bilstein rear dampers are supplied from Australia; bulky RAW rear leaf springs and matching fitting components are sourced locally through Autolign New Zealand. This gives you a choice of rear constant-load setups without importing all the leaf packs from Australia. Contact PPD Performance NZ about component availability, collection and freight throughout the North and South Islands.
Assembly and listed components included; fitting, wheel alignment, LVV certification, delivery and any additional geometry-correction parts are not included unless expressly stated. Components may be shipped or collected subject to availability.