Upgrade your Toyota Hilux N80 GUN126 4WD with Bilstein B6 monotube suspension, prepared for the way your ute is used in New Zealand. The B6 gas-pressure design helps control body movement and improve composure over corrugations, rough roads and everyday driving. Spring choice should reflect the accessories and permanent load carried by the vehicle.
The front struts are supplied fully assembled by Wilkinson Suspension in Australia with Bilstein B6 dampers, King Springs, new top mounts and assembly labour already included. These are not supplied as separate loose front components.
Rear Bilstein B6 shocks are included, but rear leaf springs and leaf fitting components are not included. This is a front suspension and rear shock package, not a complete leaf-spring lift kit.
Front spring recommendations are based on King Springs raised-coil application ranges; verify final constant front axle load and spring selection before dispatch.
Choose approximately 50 mm or 75 mm front lift. The 75 mm setup includes additional front-end geometry components; it requires installer checks for travel, clearances and NZ certification. Actual lift depends on vehicle condition and permanent load.
For applicable Toyota Hilux N80 GUN126 4WD models, subject to year and suspension specification. Excludes special wide-track Rogue / GR Sport applications unless independently confirmed. A professional alignment and suspension travel inspection are recommended. Check current NZ Low Volume Vehicle (LVV) requirements before fitting modified suspension, especially above 50 mm.
Wilkinson Suspension components come from Australia; RAW leaf springs and fittings are sourced in New Zealand. Contact PPD Performance NZ for current availability, collection and dispatch options throughout the North and South Islands. Assembly, installation, certification and ancillary corrections not explicitly listed are not included in the purchase.